Part 1 / Part 2 Finally the AHT10 and BME280 sensors have arrived. First step soldering pins. Got to unwrap my newest soldering iron. Then loading up tasmota on the nodemcu. (The same one that was already outside) Despite all the OLD instructions to edit the useroverride section in the sonoff.bin I simply downloaded the newest 6.6.0 tasmota as per instructions has i2c support for … Continue reading Replacement of the DHT22
It’s the tiniest and oddly enough I think it took the longest to arrive. Ooh another antennae. hmm this digital crop isn’t the best Nothing to see here. Only flux residue I think. This is my little translator from WIFI mqtt to whatever proprietary format the milight uses. The purchase was an idea I picked up on his page. https://github.com/sidoh/esp8266_milight_hub I bought a milight a … Continue reading NRF24L01+ Tiniest delivery yet (part 1)
It’s always a mystery what will arrive in the mail. Sometimes the delivery takes forever other times it’s here super fast. The items arrived 9 days from the purchase with free delivery. These items from different sellers must have be packed in a container that was almost full and ready to go or something. In any case I’m happy as the jump wire I wasn’t … Continue reading Colourful deliveries
AliExpress… Great asset, good selection, good prices. What’s the downside? Unless you’re into fixing new products sometimes the downside is that your product arrives with damage. More often than not the product itself will be damage free but the packaging will have gone through a heavy beating. Many people would say this is the mail service’s fault and I would agree in part. However which … Continue reading Some (re)assembly required. AliExpress damaged packaging & “broken” contents.
BRUH got me into this. BRUH disappeared. Dr ZZs can in to fill the void. The hook up is assisting. BRUH left so I’m leaving too. Yeahnah. I love ya BRUH I can’t thank you enough for your push back into the electronics field. But the truth is the BRUH multisensors sometimes reset or freeze up. I would love to ask you about it alas … Continue reading BRUH to Tasmota conversion.
When installing a reed switch or PIR sensor the output of the wires is sometimes cause for concern. In my previous setup the jumper wires came out with power cables. This eventually let to interference of the power with the PIR sensor and caused much ghosting. I had read about people sticking the wires out the top but then realized that they all drilled a … Continue reading Sonoff basic GPIO14 cabling
Not long after making my BRUH multisensors I realized I had to modify one to have 2 PIR sensors. Editing the code I managed to do just that. PIR installed. Tested and works great. It’s a multisensor in middle of a corridor with 2 AM312s pointing in opposite directions. About a month later one of the PIRs started to have ghosting or signs of failure. … Continue reading AM312 PIR issues