A project wemos d1 mini I use for tests recently froze when searching for a wifi point. The old wifi points were for some reason not disappearing but remained as if I had discovered them again. Reset button not working. So reflash it was. It has been a while since I had to wipe an esp8266 chip. I recently saw a “hook up” video and … Continue reading Noob mistake
I’m not sure just how many times I’ll say this. The Raspberry Pi although a great little pc, for hassio with over 10 data input points is just not adequate. If hassio is going to eat my sd cards at the rate of 2-3 per year it’s just not worth it long run. This is a HUGE minus on the WAF (wife approval factor) and … Continue reading Hassio still not for the masses. SD card buffet…
There is much more serious news with regards to typhoons. This isn’t to belittle the importance of actual news, obviously. Ugh…Typhoons. In 2018 my wireless ipcam died. It was replaced by a whole NVR system for the outdoors. (Which has been a non iot post in draft mode for a year now) Countless dht22s and now the latest victim, my new BME280 which was outside … Continue reading Super Typhoon 11 (2019) AKA “Krosa” claims another sensor.
In my kitchen I have 2 sonoffs. One in the overhead ceiling lamp (the wall switch didn’t have the ground/earth wire) There is another sonoff attached to a wall mounted “tv” from reusing a pc monitor and a firestick 2nd gen. In order to save a sonoff and place it elsewhere as well as centralizing all the iot in one spot I though I’d take … Continue reading Combining multisensor and sonoff
Last year I’ve had to replace the DHT-22 outdoor sensor several times during the peak and constant high humidity levels and the rainy season. I had discovered the BME280 sensor and read many good reviews. Wemos D1 Mini and BME280 Temperature, Humidity and Pressure Sensor Compare different i2c temperature and humidity sensors (SHT2x, SHT3x, SHT85, ..) Mentioned previously part1 part2 part3 I recently converted my … Continue reading Wayyyy too hot and humid but the BME280 troops on.
It moved and I had forgotten. I spent a silly amount of time looking for it again (under advanced). This happened as I had too many update notes to read after updating from 0.92.1 to 0.96.5. 0.97 has many more such surprises in store apparently. I haven’t really taken the time to read the home assistant road map. However I’m still pretty confident that even … Continue reading Configuration validation…
Part 1 / Part 2 Finally the AHT10 and BME280 sensors have arrived. First step soldering pins. Got to unwrap my newest soldering iron. Then loading up tasmota on the nodemcu. (The same one that was already outside) Despite all the OLD instructions to edit the useroverride section in the sonoff.bin I simply downloaded the newest 6.6.0 tasmota as per instructions has i2c support for … Continue reading Replacement of the DHT22