There is much more serious news with regards to typhoons. This isn’t to belittle the importance of actual news, obviously. Ugh…Typhoons. In 2018 my wireless ipcam died. It was replaced by a whole NVR system for the outdoors. (Which has been a non iot post in draft mode for a year now) Countless dht22s and now the latest victim, my new BME280 which was outside … Continue reading Super Typhoon 11 (2019) AKA “Krosa” claims another sensor.
Last year I’ve had to replace the DHT-22 outdoor sensor several times during the peak and constant high humidity levels and the rainy season. I had discovered the BME280 sensor and read many good reviews. Wemos D1 Mini and BME280 Temperature, Humidity and Pressure Sensor Compare different i2c temperature and humidity sensors (SHT2x, SHT3x, SHT85, ..) Mentioned previously part1 part2 part3 I recently converted my … Continue reading Wayyyy too hot and humid but the BME280 troops on.
Part 1 / Part 2 Finally the AHT10 and BME280 sensors have arrived. First step soldering pins. Got to unwrap my newest soldering iron. Then loading up tasmota on the nodemcu. (The same one that was already outside) Despite all the OLD instructions to edit the useroverride section in the sonoff.bin I simply downloaded the newest 6.6.0 tasmota as per instructions has i2c support for … Continue reading Replacement of the DHT22
After 2 months suddenly it stopped registering humidity.The reading for a few days were very high. I chalked it off as the humidity factor as we enter the rainy season. But today was 45-50% humidity.Even the wash area sensor registered 60.Something was wrong.It seemed to be recovering a little but i no longer felt it was accurate. So I swapped it for the DHT22 in … Continue reading DHT22 AM2302